Sanyo SCP5400 User Guide - Page 23

Turning Your Phone ON and OFF Turning Your Phone On Ⅵ Press to turn your phone on. Note: When you turn on your phone for the first time, you will be asked to activate PCS Ready Link service. Press or OK (left softkey) to use PCS Ready Link service. Once your phone is On, it displays "Looking for service..." which indicates that your phone is searching for a signal. When your phone finds a signal, it automatically enters standby mode - the phone's idle state. At this point, you are ready to begin making and receiving calls. If your phone is unable to find a signal after 15 minutes of searching, a Power Save feature is automatically activated. When a signal is found, your phone automatically returns to standby mode. In Power Save mode, your phone searches for a signal periodically without your intervention. You can also initiate a search for PCS Service by pressing any key (when your phone is turned On). Tip: The Power Save feature helps to conserve your battery power when you are in an area where there is no signal. Turning Your Phone Off Ⅵ Press for two seconds until you see the powering down animation on the display screen. Your screen remains blank while your phone is off (unless the battery is charging). Section 2: Understanding Your PCS Phone 2A: Your PCS Phone - The Basics 12