Sony STR-DN1070 Help Guide Printable PDF - Page 101

[138] Adjusting Settings Performing Auto Calibration 3. Connecting the calibration microphone Calibration microphone (supplied) 1 Connect the supplied calibration microphone to the CALIBRATION MIC jack. 2 Set up the calibration microphone. Place the calibration microphone at your listening position and set it at the same height as your ears. [139] Adjusting Settings Performing Auto Calibration 4. Selecting the front speakers You can select the front speakers you want to operate. Be sure to use the buttons on the receiver to perform this operation. 1 Press SPEAKERS on the receiver repeatedly to select the front speaker system you want to operate. The indicators on the display panel shows which set of terminals are selected. SPA: Speakers connected to the SPEAKERS FRONT A terminals. SPB (*): Speakers connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B terminals. SPA+B (*): Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B terminals (parallel connection). (None): [SPK OFF] appears on the display panel. No audio signals are output from any speaker terminals. * To select [SPB] or [SPA+B], set the assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B terminals to [Front B] by using [Surround Back Speaker Assign] in the [Speaker Settings] menu. Note This setting is not available when headphones are connected. When you press SPEAKERS on the receiver, the [Bluetooth Mode] changes to [Receiver] automatically.