Sony STR-DN1070 Help Guide Printable PDF - Page 44
Checking Auto Calibration results, Enjoying video and sound
View all Sony STR-DN1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
[47] Preparation Performing Auto Calibration 6. Checking Auto Calibration results To check error codes or warning messages received in [Auto Calibration], proceed with the following steps: If an error code appears Check the error and perform Auto Calibration again. 1 Select [Retry]. 2 Follow the instructions on the TV screen and then press to select [Start]. The measurement starts in a few seconds. The measurement process will take approximately 30 seconds with a test tone. When the measurement ends, a beep sounds and the screen switches. 3 Select the item you want. Save: Saves the measurement results and exits the setting process. Retry: Performs the Auto Calibration again. Discard: Exits the setting process without saving the measurement results. 4 Save the measurement results. Select [Save] in step 3. If a warning message appears Check the warning message and select [OK]. For details on the warning messages, see "List of messages after Auto Calibration measurements." Hint The measurement results may vary depending on the position of the subwoofer. However, continuing to use the receiver with that value does not cause problems. [48] Enjoying Video and Sound Playing AV devices Enjoying video and sound This topic explains the operations you can use to enjoy movies and music with this receiver. For example, you can use multiple devices with this receiver as shown below.