Sony STR-DN1070 Help Guide Printable PDF - Page 104

[143] Adjusting Settings Performing Auto Calibration Selecting the Auto Calibration type (Calibration Type) You can select a calibration type after you have performed the Auto Calibration and saved the settings. 1 Select [Setup] - [Speaker Settings] from the home menu. 2 Select [Calibration Type]. 3 Select the setting you want. Full Flat: Makes the measurement of frequency from each speaker flat. Engineer: Sets to "the Sony listening room standard" frequency characteristics. Front Reference: Adjusts the characteristics of all of the speakers to match the characteristics of the front speaker. Off Note This function does not work in the following cases: Headphones are connected. [Auto Calibration] has not been performed. [Bluetooth Mode] is set to [Transmitter]. The receiver may play signals at a lower sampling frequency than the actual sampling frequency of the input signals, depending on the audio format. [144] Adjusting Settings Speaker Settings Selecting the speaker pattern (Speaker Pattern) You can select the speaker pattern you want according to your speaker installation. 1 Select [Setup] - [Speaker Settings] from the home menu. 2 Select [Speaker Pattern]. 3 Select the desired speaker pattern according to the speaker installation example displayed on the TV screen, then select [Save]. Note This function does not work in the following cases: Headphones are connected. [Bluetooth Mode] is set to [Transmitter]. If you select a speaker pattern with the speakers connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B terminals and select [Save], [Zone2 Power] will be set to [Off] automatically.