Sony STR-DN1070 Help Guide Printable PDF - Page 42
Connecting the calibration microphone, Selecting the front speakers
View all Sony STR-DN1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Note Auto Calibration is not available when [Bluetooth Mode] is set to [Transmitter]. The speakers emit very loud sound during the calibration and the volume cannot be adjusted. Be considerate of your neighbors and any children who are present. If the muting function has been activated before you perform Auto Calibration, the muting function will shut off automatically. It may not be possible to take the correct measurements or to perform Auto Calibration at all if special speakers such as dipole speakers are used. [44] Preparation Performing Auto Calibration 3. Connecting the calibration microphone Calibration microphone (supplied) 1 Connect the supplied calibration microphone to the CALIBRATION MIC jack. 2 Set up the calibration microphone. Place the calibration microphone at your listening position and set it at the same height as your ears. [45] Preparation Performing Auto Calibration 4. Selecting the front speakers You can select the front speakers you want to operate. Be sure to use the buttons on the receiver to perform this operation. 1 Press SPEAKERS on the receiver repeatedly to select the front speaker system you want to operate. The indicators on the display panel shows which set of terminals are selected. SPA: Speakers connected to the SPEAKERS FRONT A terminals. SPB (*): Speakers connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B terminals.