Yamaha MU100R MU100R Owners Manual - Page 69

Assignable Controller (AC1) 4 Try the setting on other Voices. Exit to the Multi Play mode display (press the [PLAY] button) and select other Voices, trying out the new setting, and moving the foot controller up and down as you play. Try out some of these Voices, and notice how the sound changes: SynBass2 (040), Saw Ld (082), Warm Pad (090) - for a "wah" filter sweep effect. SynVoice (055), NewAgePd (089) - for gradually fading in a breathy sound. For details on the AC1 Filter Control parameter, see page 112. Details • Keep in mind that the degree and character of the AC1 Filter Control depends also on the Filter parameter settings for the Part (see page 112). Some Voices may not change at all unless these parameters are set appropriately. However, all of the example Voices above should clearly change in response to AC1 (if the Filter parameters are all at their default setting of 00). Resetting the parameter values The simple operation below lets you instantly restore the factory preset values. Since it automatically cancels any edits you've made, you should use it with care. 1. Press the [MODE] button. 2. Select a different mode, then re-select the original one. For example, if you were editing in the XG mode, use the [SELECT ] buttons to move the cursor to "TG300," then back to "XG." Doing this automatically resets all Part settings to the factory-programmed condition and cancels any edits you made in the Multi mode (including whatever Voices you selected). 58 Guided Tour