ZyXEL ISG50-PSTN User Guide - Page 363

Chapter 23 Firewall 23.2.2 The Firewall Add/Edit Screen In the Firewall screen, click the Edit or Add icon to display the Firewall Rule Edit screen. Figure 243 Configuration > Firewall > Add The following table describes the labels in this screen. Table 118 Configuration > Firewall > Add LABEL Create new Object Enable From To DESCRIPTION Use to configure any new settings objects that you need to use in this screen. Select this check box to activate the firewall rule. For through-ISG50 rules, select the direction of travel of packets to which the rule applies. any (Excluding DEVICE) means all interfaces or VPN tunnels. Description Schedule User Device means packets destined for the ISG50 itself. Enter a descriptive name of up to 60 printable ASCII characters for the firewall rule. Spaces are allowed. Select a schedule that defines when the rule applies. Otherwise, select none and the rule is always effective. This field is not available when you are configuring a to-ISG50 rule. Select a user name or user group to which to apply the rule. The firewall rule is activated only when the specified user logs into the system and the rule will be disabled when the user logs out. Otherwise, select any and there is no need for user logging. Source Destination Service Note: If you specified a source IP address (group) instead of any in the field below, the user's IP address should be within the IP address range. Select a source address or address group for whom this rule applies. Select any if the policy is effective for every source. Select a destination address or address group for whom this rule applies. Select any if the policy is effective for every destination. Select a service or service group from the drop-down list box. ISG50 User's Guide 363