ZyXEL ISG50-PSTN User Guide - Page 98

Chapter 6 Configuration Basics 6.6.2 Licensing Registration Use these screens to register your ISG50 and subscribe to services. You must have Internet access to myZyXEL.com. MENU ITEM(S) PREREQUISITES Configuration > Licensing > Registration Internet access to myZyXEL.com 6.6.3 Interface See Section 6.3 on page 92 for background information. Note: When you create an interface, there is no security applied on it until you assign it to a zone. Most of the features that use interfaces support Ethernet, PPPoE/PPTP, cellular, VLAN, and bridge interfaces. MENU ITEM(S) PREREQUISITES WHERE USED Configuration > Network > Interface (except Network > Interface > Trunk) Port groups (configured in the Interface > Port Grouping screen) Zones, trunks, IPSec VPN, DDNS, policy routes, static routes, HTTP redirect, NAT Example: The dmz interface is in the DMZ zone and uses a private IP address. To configure dmz's settings, click Network > Interface > Ethernet and then the dmz's Edit icon. 6.6.4 Trunks Use trunks to set up load balancing using two or more interfaces. MENU ITEM(S) PREREQUISITES WHERE USED Configuration > Network > Interface > Trunk Interfaces Policy routes Example: See Chapter 7 on page 107. 6.6.5 Policy Routes Use policy routes to override the ISG50's default routing behavior in order to send packets through the appropriate interface or VPN tunnel. You can also use policy routes for bandwidth management (out of the ISG50), port triggering, and general NAT on the source address. You have to set up the criteria, next-hops, and NAT settings first. MENU ITEM(S) Configuration > Network > Routing > Policy Route 98 ISG50 User's Guide