ZyXEL P-202H User Guide - Page 284
Example Xmodem Configuration Upload Using HyperTerminal
View all ZyXEL P-202H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
P-202H Plus v2 User's Guide Figure 187 Menu 24.7.2 As Seen Using the Console Port Menu 24.7.2 - System Maintenance - Upload System Configuration File To upload system configuration file: 1. Enter "y" at the prompt below to go into debug mode. 2. Enter "atlc" after "Enter Debug Mode" message. 3. Wait for "Starting XMODEM upload" message before activating Xmodem upload on your terminal. 4. After successful firmware upload, enter "atgo" to restart the system. Warning: 1. Proceeding with the upload will erase the current configuration file. 2. The system's console port speed (Menu 24.2.2) may change when it is restarted; please adjust your terminal's speed accordingly. The password may change (menu 23), also. 3. When uploading the DEFAULT configuration file, the console port speed will be reset to 9600 bps and the password to "1234". Do You Wish To Proceed:(Y/N) 2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your computer. Follow the procedure as shown previously for the HyperTerminal program. The procedure for other serial communications programs should be similar. 3 Enter "atgo" to restart the ZyXEL Device. 29.4.11 Example Xmodem Configuration Upload Using HyperTerminal Click Transfer, then Send File to display the following screen. Figure 188 Example Xmodem Upload After the configuration upload process has completed, restart the ZyXEL Device by entering "atgo". 283 Chapter 29 Firmware and Configuration File Maintenance