ZyXEL UAG715 User Guide - Page 114
and 2, Same as Area, Authentication, Interface Type, external, Clone by host, PPPoE/PPTP, Cancel
View all ZyXEL UAG715 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Chapter 8 Interfaces Table 41 Configuration > Network > Interface > Ethernet > Edit (continued) LABEL Send Version Receive Version V2-Broadcast OSPF Setting Area Priority Link Cost Passive Interface Authentication DESCRIPTION This field is effective when RIP is enabled. Select the RIP version(s) used for sending RIP packets. Choices are 1, 2, and 1 and 2. This field is effective when RIP is enabled. Select the RIP version(s) used for receiving RIP packets. Choices are 1, 2, and 1 and 2. This field is effective when RIP is enabled. Select this to send RIP-2 packets using subnet broadcasting; otherwise, the UAG uses multicasting. See Section 11.3 on page 167 for more information about OSPF. Select the area in which this interface belongs. Select None to disable OSPF in this interface. Enter the priority (between 0 and 255) of this interface when the area is looking for a Designated Router (DR) or Backup Designated Router (BDR). The highest-priority interface identifies the DR, and the second-highest-priority interface identifies the BDR. Set the priority to zero if the interface can not be the DR or BDR. Enter the cost (between 1 and 65,535) to route packets through this interface. Select this to stop forwarding OSPF routing information from the selected interface. As a result, this interface only receives routing information. Select an authentication method, or disable authentication. To exchange OSPF routing information with peer border routers, you must use the same authentication method that they use. Choices are: Same as Area - use the default authentication method in the area None - disable authentication Text - authenticate OSPF routing information using a plain-text password Text Authentication Key MD5 Authentication ID MD5 Authentication Key MAC Address Setting Use Default MAC Address Overwrite Default MAC Address Related Setting Configure PPPoE/PPTP OK Cancel MD5 - authenticate OSPF routing information using MD5 encryption This field is available if the Authentication is Text. Type the password for text authentication. The key can consist of alphanumeric characters and the underscore, and it can be up to 16 characters long. This field is available if the Authentication is MD5. Type the ID for MD5 authentication. The ID can be between 1 and 255. This field is available if the Authentication is MD5. Type the password for MD5 authentication. The password can consist of alphanumeric characters and the underscore, and it can be up to 16 characters long. This section appears when Interface Type is external. Have the interface use either the factory assigned default MAC address, a manually specified MAC address, or clone the MAC address of another device or computer. Select this option to have the interface use the factory assigned default MAC address. By default, the UAG uses the factory assigned MAC address to identify itself. Select this option to have the interface use a different MAC address. Either enter the MAC address in the fields or click Clone by host and enter the IP address of the device or computer whose MAC you are cloning. Once it is successfully configured, the address will be copied to the configuration file. It will not change unless you change the setting or upload a different configuration file. Click PPPoE/PPTP if this interface's Internet connection uses PPPoE or PPTP. Click OK to save your changes back to the UAG. Click Cancel to exit this screen without saving. 114 UAG715 User's Guide