Canon imageRUNNER 1025 Series Basic Operation Guide - Page 155

Direct Sending With direct sending, the machine sends the document on the ADF as it scans one page, without storing all pages into memory at once. You can send a document ahead of other documents stored in memory. Fax (imageRUNNER 1025iF Only) - You cannot use the platen glass for direct sending. - You can specify only one destination at a time for direct sending. - You cannot use group dialing for direct sending. If you specify a group, the direct sending mode is canceled, and the document is sent in the memory sending mode. - You cannot use Two-Sided scanning mode for direct sending. - With direct sending, the machine scans one page into memory at once and sends it right away. Therefore, when is displayed, even if you have selected direct sending, wait until there is enough space in memory to scan one page, or delete the documents in memory, and try again. (See "Checking/Changing the Status of Fax Documents in Memory," on p. 5-64. 1 Load your originals in the ADF. 2 Press [SEND]. 3 Press [ ] or [ ] to select , then press [OK]. SELECT SEND METHOD FAX 5 Adjust any necessary settings for your document. You can specify the following settings: - Image Qaulity: See "Selecting Image Quality" on p. 5-29. - Density: See "Adjusting Density," on p. 5-30. - 2-Sided: See "2-Sided Originals," on p. 5-31. 6 Dial the recipient's fax/telephone number. If you select delayed transmission or sequential broadcasting, memory sending is automatically selected. If in in is set to and you specify a fax number using - [numeric keys], you must enter the fax number again for confirmation. Enter the same fax number you entered in step 6, then press [OK]. 4 Press [Direct TX]. To cancel direct sending, press [Direct TX] again. 7 Press [Start]. Each page is sent as it is scanned. During transmission, and the recipient's fax/telephone number alternately appear as messages on the display. 5-32