Canon imageRUNNER 1025 Series Basic Operation Guide - Page 81

Registering Destinations in the Address Book (imageRUNNER 1025iF Only) Storing/Editing Coded Dial Codes Registering File Server Addresses in Coded Dial Codes This section describes the procedure for registering file server addresses in the coded dial codes. You cannot change the server protocol setting (FTP or SMB) of the destination registered in Address Book. To change the server protocol, cancel the registration once, then register with the correct server protocol again. 1 Press [Additional Functions]. 2 Press [ ] or [ ] to select , then press [OK]. ADD. FUNCTIONS 4.ADDRESS BOOK SET. If a password has been set for the Address Book, enter the password using - [numeric keys], then press [OK]. 3 Press [ ] or [ ] to select , then press [OK]. ADDRESS BOOK SET. 3.CODED SPD DIAL 4 Press [ ] or [ ] to select a coded dial code (000 to 176) for which you want to register the address, then press [OK]. CODED SPD DIAL [*000]NOT REGISTERED You can also select a coded dial code by pressing [Coded Dial] followed by the desired three digit code. 5 Press [ ] or [ ] to select the server protocol ( or ), then press [OK]. CODED SPD DIAL FTP - : Select this protocol if you are sending documents to a computer running Sun Solaris 2.6 or later, Mac OS X, Internet Information Services 5.0 under Windows 2000 Server/ Windows 2008 Server, Internet Information Services 5.1 under Windows XP Professional, Internet Information Services 6.0 under Windows 2003 Server, Internet Information Services 7.0 under Windows Vista, or Red Hat Linux 7.2. - : Select this protocol if you are sending documents to a computer running UNIX/ Linux (Samba 2.2.8a or later), or Windows 2000/XP/Server 2003/Vista/Server 2008. 6 Confirm that is displayed, then press [OK]. CODED SPD DIAL 1.NAME 7 Enter the destination's name (up to 16 characters) using - [numeric keys], then press [OK]. Ex. NAME :a FTP server 3-18