Canon imageRUNNER 1025 Series Basic Operation Guide - Page 272
Error Messages
View all Canon imageRUNNER 1025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
Error Messages See the table below when the error and status messages appear on the display. Message ADJUSTING WAITING TO SCAN AUTO REDIAL CHANGE PAPERSIZE CHANGE REG'D SIZE → COMMON SETTINGS CHECK DOCUMENT CLOSE COVER FRONT OR LEFT COVER DATA ERROR DOCUMENT TOO LONG DRUM IS NOT SET INSERT THE DRUM FEEDER PAPER JAM CHECK THE FEEDER INITIALIZING... Description Action The machine is not ready for scanning. Wait until the machine is ready. This message appears when the recipient is engaged in direct sending and the job is waiting. Disappears when the transmission restarts. The size of the paper in the paper drawer or stack bypass is different from that of the paper specified in or in the menu. - Load the paper of the size shown on the display. - If you are trying to print a report or list, set the paper size to or , then load paper of the same size. - The size of the paper in the paper drawer or stack bypass is different from that of the paper specified in or in the menu. - Change the paper size setting. - The paper ran out during the print - Load paper in the paper drawer or job. stack bypass. A document jam may have occurred Remove the jammed document. in the ADF. A cover is open. Close the cover shown on the lower line of the display. The machine may have trouble. Contact your local authorized Canon dealer. The document fed from the ADF is longer than 24 7/8" (630 mm), or is not feeding correctly. - Scan the document on the platen glass. - Reduce the length of the document to within 24 7/8" (630 mm), then try again. A drum unit is not installed or not installed correctly. Install the drum unit correctly A document jam may have occurred Remove the jammed document. in the ADF. This message appears when turning Wait until the message disappears. on the main power switch, or when the machine is not ready for printing. Troubleshooting 13-7