Cisco 3825 Software Configuration Guide - Page 201
sample-rate
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference sample-rate sample-rate To specify in milliseconds the rate hardware samples the data on the attached circuit, use the sample-rate command in the circuit emulation (CEM) circuit configuration mode. sample-rate [sample-rate] Syntax Description sample rate Sample rate translates into the payload-size sent over the circuit. The default is 1 ms. • 32-timeslots at 1ms = 256-bytes (32-timeslots * 8-bytes/timeslot/ms) • 24-timeslots at 2ms = 384-bytes (24-timeslots * 16-bytes/timeslot/ms) Command Modes CEM circuit configuration Command History Release 12.4(12)MR2 Modification This command was introduced. Examples The following example illustrates the use of the sample-rate command: Router# config t Router(config)# interface cem 0/0/0 Router(config-if)# no ip address Router(config-if)# cem 0 Router(config-if-cem)# sample-rate 2 Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls Router(config-if-cem-xconn)# exit Router(config-if-cem)# exit Router(config-if)# exit Router(config)# exit Related Commands Command cem cem class class cem Description Apply CEM class. Applies the CEM interface parameters defined in the given to the circuit. Configure's CEM interface parameters in a class that's applied to CEM interfaces together in the global configuration mode. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-69