Cisco 3825 Software Configuration Guide - Page 98
umts-iub local, umts-iub remote, Step 13
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Configuration Sequence Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line For example, the following command specifies the ATM PVC interface with a VPI of 2and a VCI of 1: Router(config-if)# pvc 2/1 Note PVC definitions should match those on the NodeB and use the following definitions: NBAP signaling-use qsaal ALCAP signaling-use qsaal AAL2 bearer-use encapsulation aal0 All other PVCs should use encapsulation aal0 Class of service should be defined to match the NodeB PVC class of service definitions. For instance, if the NodeB has defined a PVC with CBR, the PVC on the Cisco 3825 router should use the same CBR definitions. OAM can be defined on the PVCs as well. If the NodeB has OAM enabled on its PVC, OAM should be defined on the PVCs of the Cisco 3825 router as well. Step 13 Configure the AAL and encapsulation type to AAL0 encapsulation. Router(config-if)# encapsulation aal-encap Where aal-encap specifies the AAL and encapsulation type. For example, the following command specifies the AAL as AAL0: Router(config-if)# encapsulation aal0 Step 14 Step 15 Perform Steps 12 and 13 to add another ATM PVC. To configure the local parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from. Router(config-if)# umts-iub local ip-address port For example, the following command configures the umts-iub local interface with an IP address and port of 20.20.20.21 6666: Router(config-if)# umts-iub local 20.20.20.21 6666 Step 16 To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from. Router(config-if)# umts-iub remote ip-address port For example, the following command configures the umts-iub remote interface with an IP address and port of 20.20.20.20 6666: Router(config-if)# umts-iub remote 20.20.20.20 6666 Step 17 Exit the interface configuration mode. Router(config-if)# exit 4-40 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03