Cisco SPA112 Administration Guide - Page 105
G726-24, G729a, or G723. Default, Use Pref Codec Only - fax settings
View all Cisco SPA112 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Configuring Voice Configuring Voice Settings 4 Field Description Third Preferred Codec Third preferred codec for all calls. (The actual codec used in a call still depends on the outcome of the codec negotiation protocol.) Select one of the following: Unspecified, G711u, G711a, G726-16, G726-24, G726-32, G726-40, G729a, or G723. Default setting: Unspecified Use Pref Codec Only To use only the preferred codec for all calls, select yes. (The call fails if the far end does not support this codec.) Otherwise, select no. Default setting: no G729a Enable To enable the use of the G.729a codec at 8 kbps, select yes. Otherwise, select no. Default setting: Yes Silence Supp Enable To enable silence suppression so that silent audio frames are not transmitted, select yes. Otherwise, select no. Default setting: no G726-32 Enable To enable the use of the G.726 codec at 32 kbps, select yes. Otherwise, select no. Default setting: Yes Silence Threshold Select the appropriate setting for the threshold: high, medium, or low. Default setting: medium FAX V21 Detect Enable To enable detection of V21 fax tones, select yes. Otherwise, select no. Default setting: Yes Echo Canc Enable To enable the use of the echo canceller, select yes. Otherwise, select no. Default setting: Yes FAX CNG Detect Enable To enable detection of the fax Calling Tone (CNG), select yes. Otherwise, select no. Default setting: Yes Echo Canc Adapt Enable To enable the echo canceller to adapt, select yes. Otherwise, select no. Default setting: Yes FAX Passthru Codec Select the codec for fax passthrough, G711u or G711a. Default setting: G711u Echo Supp Enable To enable the use of the echo suppressor, select yes. Otherwise, select no. Default setting: Yes FAX Codec Symmetric To force the ATA to use a symmetric codec during fax passthrough, select yes. Otherwise, select no. Default setting: Yes Cisco SPA100 Series Phone Adapters Administration Guide 105