Cisco SPA112 Administration Guide - Page 20
Network Settings for the LAN and DHCP Server (SPA122 Only), Network Setup, Basic - default ip
View all Cisco SPA112 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Configuring the Network Basic Setup 3 Network Settings for the LAN and DHCP Server (SPA122 Only) Use the Network Setup > Basic Setup > Network Settings page to set the IP address and subnet mask for your local network. Also configure the settings for the built-in DHCP server. To open this page: Click Network Setup in the menu bar, and then click Basic Setup > Network Settings in the navigation tree. Enter the settings as described below. After making changes, click Submit to save your settings, or click Cancel to abandon any unsaved entries. Router IP Enter the IP address and subnet mask for your local network. The default setting is 192.168.15.1/24. DHCP Server Setting Field DHCP Server Description The ATA can use the built-in DHCP server to dynamically assign IP addresses to connected devices. Click Enabled to enable the DHCP server, or click Disabled to disable this feature. Cisco SPA100 Series Phone Adapters Administration Guide 20