Cisco SPA112 Administration Guide - Page 51
Resetting the Control Timers, Configuring Voice, Digit Sequences, - default username password
View all Cisco SPA112 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Configuring Voice Configuring Dial Plans 4 SYNTAX 2: sequence Ss Use this syntax to apply the new setting to a particular dialing sequence. s: The number of seconds; if no number is entered after S, the default timer of 5 seconds applies. Examples for the Interdigit Short Timer Set the timer for the entire dial plan. S:6,(9,8[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx) S:6, While entering a number with the phone off hook, a user can pause for up to 15 seconds between digits before the Interdigit Short Timer expires. Set an instant timer for a particular sequence within the dial plan. (9,8[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxxS0 | 9,8,011xx. | 9,8,xx.|[1-8]xx) 9,8,1[2-9]xxxxxxxxxS0 With the timer set to 0, the call is transmitted automatically when the user dials the final digit in the sequence. Resetting the Control Timers You can use the following procedure to reset the default timer settings for all calls. NOTE To edit a timer setting only for a particular digit sequence or type of call, you can edit the dial plan. See Digit Sequences, page 43. STEP 1 Log in to the configuration utility. If prompted, enter the administrative logon provided by the Service Provider. The default username and password are both admin. STEP 2 Under the Voice menu, click Regional. STEP 3 In the Control Timer Values section, enter the desired values in the Interdigit Long Timer field and the Interdigit Short Timer field. See the definitions at the beginning of this section. Cisco SPA100 Series Phone Adapters Administration Guide 51