Dell PowerVault 56F Dell PowerVault 51F 8-Port Fibre Channel Switch Insta - Page 144
Panic Errors, Table A-1., Errors
View all Dell PowerVault 56F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Table A-1. Errors (continued) Module Error Severity Explanation MSG (3) The timer task received an unknown message. Action Contact customer support. Panic Errors This module includes errors that cause a system panic to occur. A system panic causes the switch to reboot. The PANIC error is stored in flash memory with a stack trace, local stack content and local register content at the time the error occurred. To view the trace, allow the switch to reboot and issue the traceShow command. If the trace was caused by a PANIC error, the first line displays: Reset reasons 0x100: Panic PANIC errors have the highest severity (0). NOTE: Use the traceShow command to identify PANIC errors as the errShow command is not useful in this case. Panic errors are described in Table A-2. Table A-2. Panic Errors Error Severity Explanation FREETIMRLSD (0) A task freed an already free timer. INCONSiSTENT (0) An internal inconsistency has been detected. MALLOC (0) The switch has run out of memory. MSGQCREATE (0) A message queue could not be created. MSGQDELETE (0) A message queue could not be destroyed. SEMCREATE (0) A semaphore could not be created. SEMDELETE (0) A semaphore could not be destroyed. Action Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. Issue the traceShow command. Contact customer support. A-6 Installation and Troubleshooting Guide