Dell PowerVault 56F Dell PowerVault 51F 8-Port Fibre Channel Switch Insta - Page 93
syslogdIp, tempShow
View all Dell PowerVault 56F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Table 4-16. switchShow Command Field Descriptions (continued) Field Description Port state The port state follows the GBIC type. The possible port states include: • No_Card - No card present in this switch slot • No_Module - No GBIC module in this port • No_Light - The module is not receiving light • No_Sync - The module is receiving light but is out of sync • In_Sync - The module is receiving light and is in sync • Laser_Flt - The module is signaling a laser fault (defec- tive GBIC) • Port_Flt - The port has been marked faulty (defective GBIC, cable, or device) • Diag_Flt - The port failed diagnostics (defective G_Port or FL_Port card or system board) • Online - The port is up and running • Lock_Ref - The port locking to the reference signal • Testing - Running diagnostics Comment field The comment field follows the port state. The possible comments include: • Disabled - The port is disabled • Loopback - The port is in loopback mode • E_Port - The WWN and switch name of the other switch is shown, the use of this Inter Switch Link (ISL) is shown (see FC_SW) • F_Port - The WWN of the N_Port is shown • G_Port - The port is online but is not yet an E_Port or F_Port • L_Port - The port is connected to an arbitrated loop syslogdIp The syslogdIp command sets or displays the switches system log daemon IP address. The command syntax is syslogdip . tempShow The following example shows the tempShow command screen, which shows the switch's temperature as measured by five sensors on the system board. support.dell.com PowerVault 51F Commands 4-31