Dell QLogic Family of Adapters QLogic QME8242 Mezzanine Card User's Guide - Page 116

iBFT Boot Setup: QLogic QME8242 Mezzanine Card User's Guide 7. Press the key to return to the Adapter Settings menu. 8. On the Adapter Settings menu, select Primary Target Settings, and then press . 9. Under Target Settings, configure the following, as shown in Figure 4: a. Set the Target Name, Target IP Address, Target Port, and Boot LUN to the appropriate settings for the target setup. b. (Optional) Specify the CHAP Type as one of the following: None to disable CHAP One-Way for a target-authenticating initiator Mutual to enable both the target and initiator to authenticate each other c. (Optional) Configure the Target CHAP Name and Target CHAP Secret as needed. Figure 4. Configuring Target Settings for IPv4 (Static) 10. Press the key and save the settings. 11. Reboot the system. Setting Up a Dynamic IPv4 Address To set up a dynamic IP address on IPv4, follow these steps: file:///T|/htdocs/NETWORK/QLogic/71922/en/ibft.htm[9/26/2012 4:26:32 PM]