Dell QLogic Family of Adapters QLogic QME8242 Mezzanine Card User's Guide - Page 117

iBFT Boot Setup: QLogic QME8242 Mezzanine Card User's Guide 1. Start the server and when the NIC boot code banner appears, press the keys. The QLogic CNA Function Configuration utility opens to the Select Adapter menu. 2. Select the adapter to configure, and then press the key. The QLogic CNA Function Configuration utility opens to the Setup menu for the selected adapter. 3. Under Function Configuration, select the iBFT function to configure, and then press . 4. Under Adapter Settings, configure the following, as shown in Figure 5: a. Set Enable ROM to Enabled. b. Set IP Format to IPv4. c. Set the VLAN Mode to one of the following: Disabled if the VLAN is not used in the network Enabled to specify a valid VLAN ID d. If VLAN is enabled, specify a valid VLAN ID in the range of 2 to 4095. Figure 5. Configuring Adapter Settings for IPv4 (Dynamic) 5. Under Adapter Settings, select Initiator Settings, and then press . 6. Under Initiator Settings, configure the following, as shown in Figure 6: a. Set Enable DHCP to Enabled. b. Set Target Param to DHCP to one of the following: Disabled to manually configure the target settings (see step 9). Enabled to automatically obtain the target settings from the DHCP server, which must provide the RootPath Option (option 17) to its client. The option field string should have the following format: iscsi::tcp::: c. (Optional) Configure the Reverse CHAP Name and Reverse CHAP Secret as needed. d. Press to save these settings. Figure 6. Configuring Initiator Settings for IPv4 (Dynamic) file:///T|/htdocs/NETWORK/QLogic/71922/en/ibft.htm[9/26/2012 4:26:32 PM]