Dell QLogic Family of Adapters QLogic QME8242 Mezzanine Card User's Guide - Page 86

User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide qaucli -nic [options] netscli [options] qaucli iscsi [options] iscli [options] qaucli -fc [options] scli [options] Use NIC legacy command line Use NIC legacy command line Use iSCSI legacy command line Use iSCSI legacy command line Use Fibre Channel legacy command line Use Fibre Channel legacy command line Diagnostic help commands, and command options available for each specific protocol, are available by specifying -h to the protocol, as shown in Table 3. Table 3. Windows QConvergeConsole CLI-Getting Help Command -h qaucli -pr nic -h qaucli -pr fc -h qaucli -pr iscsi -h qaucli -npar -h Description Print usage of a specific adapter type, and then exit Print NIC protocol usage, and then exit Print Fibre Channel and FCoE protocol usage, and then exit Print iSCSI protocol usage, and then exit Print NPAR commands usage, and then exit Table 4 lists miscellaneous Windows diagnostics commands. Table 4. Windows QConvergeConsole CLI-Miscellaneous Commands Command qaucli -v qaucli -h Description Print version number, and then exit Print usage, and then exit Table 5 lists the Windows CLI diagnostic test commands. Note that while running these tests, network traffic is interrupted. Table 5. Windows QConvergeConsole CLI-Diagnostic Test Commands Command -i --interface -a --all -D --default -R --CRegs -I --IRQS -L --IntLB -H --Hw -S Description Specifies the interface type (NX_NIC, NX_NIC1, and so on) Perform all test, regardless of default Perform only default test Test all control registers (default) Test interrupt mechanism (default) Internal loopback test (default) Hardware test (default) Link status test (default) file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]