Dell QLogic Family of Adapters QLogic QME8242 Mezzanine Card User's Guide - Page 87

User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide --LinkST -nR --noCRegs -nl --noIRQS -nL --noIntLP -nH --noHw -nS --noLinkSt -h --help No control registers test (combine -D or -a) No interrupt test (combine -D or -a) No internal loopback test (combine -D or -a) No hardware test (combine -D or -a) No link status test (combine -D or -a) View help text For every test performed, the diagnostic utility shows the following data: Total number of attempts Number of successful completions Number of failures You can either perform all tests in succession, or perform only specific tests specified by the preceding command-line parameters. You can run additional diagnostics in the CLI as listed in the following table. To determine the cna_port_inst, issue the qaucli -nic -i command as shown in Table 6. Table 6. Running Windows Diagnostic Tests in the CLI Test Type External Loopback Flash Hardware Internal Loopback Interrupt Link Ping (IPv4) Register Transceiver DMI Data Command qaucli -nic -extloopback Where specifies the number of tests, 1-65535, and > is either 0=Ignore or 1=Abort. NOTE: This test requires a pass-through module to be configured for both ports. Test runs between two ports. Single port loopback is not supported. qaucli -nic -testflash [cna_port_inst] qaucli -nic -testhw [cna_port_inst] qaucli -nic -intloopback Where specifies the number of tests, 1-65535, and > is either 0=Ignore or 1=Abort. qaucli -nic -testinterrupt [cna_port_inst] qaucli -nic -testlink [cna_port_inst] qaucli -nic -ping [ ] Where the default values are count=5, pocket_size=525, timeout_ms=1000, and TTL=30. qaucli -nic -testregister [cna_port_inst] qaucli -nic -trans [cna_port_inst] Windows Diagnostic Test Descriptions file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]