HP Scitex LX600 HP Scitex LX Printer Family - User's guide - Page 16
Turn off the HP Internal Print Server computer from the Windows
View all HP Scitex LX600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
6. Press the Power Enable button at the rear left of the printer. This enables all of the printer's highpower subsystems. 7. Check that the orange light in the button comes on. In normal operation this light should always be on. If at any time you notice that this light is off, check the front panel in case there is a system error, and consult the Maintenance and troubleshooting guide. 8. Wait for the front panel to indicate that the printer is ready. This can take several minutes. The printer beeps if some problem is encountered. When initialization is complete, the front panel displays a Ready message. If a system error message is displayed, consult the Maintenance and troubleshooting guide. To turn off the printer and the HP Internal Print Server computer: 1. Wait for the front panel to indicate that the printer is ready. NOTE: If the printer fails to reach the Ready state because of a fault, continue to the next step. 2. Turn off the HP Internal Print Server computer from the Windows start button, and wait until you see a black screen with the message No input signal. CAUTION: The computer may be damaged if it is turned off incorrectly. NOTE: If the HP Internal Print Server fails to display No input signal because of a fault, continue to the next step. 3. Press the Power key on the front panel and wait for the front-panel display to turn black; this usually takes about a minute. However, after some error conditions (such as after a substrate jam), you may need to wait up to four minutes. NOTE: After the printer electronics have been turned off at the front panel, the fans turn at maximum speed, for safety reasons. This is normal behavior and not a cause for concern. NOTE: If you have waited more than five minutes and the front-panel display has not turned black because of a fault, continue to the next step. 4. Turn the big switch at the rear left of the printer to the off position. The fans should stop. TIP: If you are not planning to use the printer for some days, you are recommended to disconnect all ink cartridge connectors. To turn off the printer but not the HP Internal Print Server computer: 1. Wait for the front panel to indicate that the printer is ready. 2. Press the Power key on the front panel and wait for the front-panel display to turn black; this usually takes about a minute. However, after some error conditions (such as after a substrate jam), you may need to wait up to four minutes. NOTE: After the printer electronics have been turned off at the front panel, the fans turn at maximum speed, for safety reasons. This is normal behavior and not a cause for concern. 3. Turn circuit breakers ACB-1 (mono-phase) and ACB-3 (three-phase) to the down position. The fans should stop. To turn off the HP Internal Print Server computer but not the printer, turn off the computer from the Windows start button, and wait until you see a black screen with the message No input signal. Then turn circuit breaker ACB-2 to the down position. To stop the printer in emergency, hit one of the emergency stop buttons at the front or rear of the printer. A system error message is displayed on the front panel, and the fans turn at maximum speed. Ensure that all emergency stop buttons are released before restarting the printer. 12 Chapter 2 Basic setup options ENWW