HP StorageWorks 1606 Brocade Web Tools Administrator's Guide v6.3.0 (53-100134 - Page 241

Setting up iSCSI Target Gateway Services 15 Configuring the IP interface This step configures iSCSI ports (GbE Ports) found on the FC4-16IP. You must have at least one iSCSI port configured to log into the iSCSI target. There are two steps in this process: • Configure the IP interface for iSCSI port. • Configure the IP route for the iSCSI port. The iSCSI Port Group tab allows you to configure iSCSI ports, display session details on a port, and show the port statistics. It also allows you to view and configure the IP interface and routes that are located on the IP Interface tab. You can edit or delete the IP address, but you cannot add any additional IP addresses to this interface. When you select the switch in the left pane, the right pane lists the tasks you can perform on that switch in relation to one of the GbE ports. When you select one of the GbE ports, you can perform the same tasks listed previously: view and capture statistics related to the port, add or delete IP addresses, add or delete IP routes, view current sessions, and view the iSCSI statistics in brief. FIGURE 108 iSCSI Port tab If an IP address or IP route is already configured on the GbE port, then it will not be editable as any edits will disrupt any iSCSI traffic. Web Tools Administrator's Guide 209 53-1001343-01