HP StorageWorks 1606 Brocade Web Tools Administrator's Guide v6.3.0 (53-100134 - Page 276

17 Authentication policy configuration 3. Under Security Policies, click FWCP. 4. Select one of the following consistency behavior for the required policy type (SCC, DCC, FCS). • Absent • Tolerant • Strict NOTE You can change the consistency behavior of SCC, DCC, or FCS policy only for a primary switch. 5. Click Apply and a dialog box displays as follows. 6. Click Yes to accept the changes. If the switch is not a primary switch, an error message dialog box is displayed as shown below. Click No to discard the changes and click Refresh in the FWCP Configuration window to manually refresh the window. 7. Click Close. Authentication policy configuration You can configure an authentication protocol policy for E_Port and F_Port authentication, and then distribute the authentication policy to other switches in the fabric. You can also set shared secret keys. Configuring authentication policies for E_Ports Use the following procedure to configure authentication policies for E_Ports. 1. Open the Switch Administration window as described on page 41. 2. Click the Security Policies tab. 3. Click Authentication on the Security Policies menu. 244 Web Tools Administrator's Guide 53-1001343-01