HP StorageWorks 1606 Brocade Web Tools Administrator's Guide v6.3.0 (53-100134 - Page 75

Netstat Performance 3 5. You can also enable automatic configuration of IPv6 addresses by selecting Enable IPV6 Auto Configuration. The automatically generated IPv6 addresses are displayed under Auto Configured IPV6 Addresses. Eight auto-configured addresses are created per switch, and up to 24 for a 48000, DCX, or DCX-4S chassis (eight per chassis, and eight per each installed CP). Netstat Performance The Netstat Performance window displays the details about Ethernet management port statistics like the Interface, MTU, Met, RX-OK, RX-ERR, RX-DRP, RX-OVR, TX-OK, TX-ERR, TX-DRP, TX-OVR, and Flag. 1. Open the Switch Administration window as described on page 41. 2. Click the Network tab (Figure 21). 3. Click Netstat Performance. FIGURE 22 Netstat Performance 4. Select the Auto Refresh check box to automatically refresh the statistics details. Clear the check box to disable auto refresh. 5. When enabled, enter the interval time in seconds in the Auto-Refresh Interval field. The statistics details will be automatically refreshed based on the configured time interval. Configuring a syslog IP address The syslog IP represents the IP address of the server that is running the syslog process. The syslog daemon reads and forwards system messages to the appropriate log files or users, depending on the system configuration. When one or more IP addresses are configured, the switch forwards all error log entries to the syslog on the specified servers. Up to six servers are supported. Refer to Fabric OS Administrator's Guide for more information on configuring the syslog daemon. Use the following procedure to configure a syslog IP address. 1. Open the Switch Administration window as described on page 41. 2. Click the Network tab (Figure 21). Web Tools Administrator's Guide 43 53-1001343-01