HP StorageWorks 1606 Brocade Web Tools Administrator's Guide v6.3.0 (53-100134 - Page 356

19 Enabling and disabling LLDP Enabling and disabling LLDP To enable or disable LLDP on a CEE interface, perform the following steps. 1. Select the CEE Interfaces tab on the Port Administration panel. 2. Under the CEE Interface Explorer, select the port. 3. Select the General tab. 4. Select Edit Configuration. The CEE Edit Configuration dialog box is displayed. 5. For LLDP Status, select Enable or Disable. Enabling and disabling QoS priority-based flow control Priority-based flow control (PFC) can be used to control network congestion. PFC can be used to selectively pause lower priority traffic classes to ensure that high priority and delay-sensitive traffic are not affected by network congestion. For example, if a large storage transfer is monopolizing the network and causing congestion, PFC can be used to pause the storage transfer so other traffic may use the network. To enable or disable PFC, perform the following steps. 1. Select the CEE tab on the Switch Administration panel. 2. Select the QoS tab. 3. Select the CEE Maps tab. 4. Under Priority Group, enable or disable Priority Flow Control Status per each Priority Group ID. Enabling and disabling FCoE ports You can enable and disable FCoE Ports individually from the Port Administration panel. 1. Select the FCoE Ports tab on the Port Administration panel. 2. Select the port you want to enable or disable under the FC0E Ports Explorer, or from the list. 3. Click Enable or Disable to change the current status of the port. 324 Web Tools Administrator's Guide 53-1001343-01