Ricoh Aficio MP 2500 Network Guide - Page 118

Interface interface name: Duplicate IP Ad, Name registration success. WINS Serv

Get Ricoh Aficio MP 2500 PDF manuals and user guides View all Ricoh Aficio MP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 118 highlights

Monitoring and Configuring the Printer Message Interface (interface name): Duplicate IP Address (IP address). < Interface >: Subnet overlap. 2 IPP cancel-job: permission denied. IPP job canceled. jobid=%d. LEAP challenge to access point failed LeaseTime=(sec), RenewTime=(sec). Login to fileserver (,) Memory allocate error. MIC failure TKIP counter measures started MIC failure TKIP counter measures stopped Name registration success. WINS Server= NetBIOS Name= Name registration success in Broadcast name= Name registration failed. name= nbtd start. no RADIUS/authentication server no smart card detected on device nprinter start (Netware) nwstart start. (NetWare) Open log file Print queue cannot be serviced by printer 0, 110 Problem and solutions The same IP (IPv4 or IPv6) address was used. Each IP address must be unique. Check the address of the device indicated in [IP address]. The same IP address (IPv, orIPv6 address) and the subnet mask is used with other device. The printer could not authenticate the name of the user attempting to cancel a job. The spooled job was canceled due to error or user request. LEAP authentication has failed. The resource lease time received from the DHCP server is displayed in [lease time] in seconds. The renewal time is displayed in [renew time] in seconds. (In the print server mode) Login to the file server is in the NDS or BINDERY mode. Data cannot be obtained. Disconnect the USB cable, and then connect it. An attack was detected during TKIP operation and the computer has taken countermeasures. Following attack during TKIP operation, the computer has ended attack countermeasures after 60 seconds. Name registration of to was successful. Name registration by Broadcast name of was successful. Name registration of failed. Change to different NetBIOS name. The nbtd service has started. A RADIUS server could not be found. No smartcard was detected on the computer during GTC authentication. (In the remote printer mode) The NetWare service has started. The service for NetWare protocol stack setting has started. (In the print server mode)The specified log file has been opened. (In the print server mode) The print queue cannot be established. Make sure that print queue exists on the specified file server.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
Monitoring and Configuring the Printer
110
2
Interface (interface name): Duplicate IP Ad-
dress (IP address).
The same IP (IPv4 or IPv6) address was used.
Each IP address must be unique. Check the ad-
dress of the device indicated in [IP address].
< Interface >: Subnet overlap.
The same IP address (IPv, orIPv6 address) and
the subnet mask is used with other device.
IPP cancel-job: permission denied.
The printer could not authenticate the name of
the user attempting to cancel a job.
IPP job canceled. jobid=%d.
The spooled job was canceled due to error or
user request.
LEAP challenge to access point failed
LEAP authentication has failed.
LeaseTime=<lease time>(sec), Renew-
Time=<renewtime>(sec).
The resource lease time received from the
DHCP server is displayed in [lease time] in
seconds. The renewal time is displayed in [re-
new time] in seconds.
Login to fileserver <file server name>
(<IPX|IPv4|IPv6>,<NDS|BINDERY>)
(In the print server mode) Login to the file
server is in the NDS or BINDERY mode.
Memory allocate error.
Data cannot be obtained.
Disconnect the USB cable, and then connect it.
MIC failure TKIP counter measures started
An attack was detected during TKIP operation
and the computer has taken countermeasures.
MIC failure TKIP counter measures stopped
Following attack during TKIP operation, the
computer has ended attack countermeasures
after 60 seconds.
Name registration success. WINS Serv-
er=<WINS server address> NetBIOS
Name=<NetBIOS name>
Name registration of <NetBIOS Name> to
<WINS server address> was successful.
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration by Broadcast name of <Net-
BIOS Name> was successful.
Name registration failed. name=<NetBIOS
name>
Name registration of <NetBIOSName> failed.
Change to different NetBIOS name.
nbtd start.
The nbtd service has started.
no RADIUS/authentication server
A RADIUS server could not be found.
no smart card detected on device
No smartcard was detected on the computer
during GTC authentication.
nprinter start (Netware)
(In the remote printer mode) The NetWare
service has started.
nwstart start. (NetWare)
The service for NetWare protocol stack setting
has started.
Open log file <file name>
(In the print server mode)The specified log file
has been opened.
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
Message
Problem and solutions