Ricoh Aficio MP 2500 Network Guide - Page 76
hostname, ifconfig, View settings, IPv4 Configuration
View all Ricoh Aficio MP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Monitoring and Configuring the Printer hostname Use the "hostname" command to change the printer name. ❖ View settings msh> hostname 2 ❖ IPv4 Configuration msh> hostname "interface_name " "printer_name" • Enter the printer name using up to 63 alphanumeric characters. • You cannot use a printer name beginning "RNP" (in either upper or lower case). • The Ethernet interface and IEEE 802.11b interface will have the same printer name. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name ether wlan Interface configured Ethernet interface IEEE 802.11b interface ❖ Initializing the printer name for each interface msh>hostname "interface_name" clear name ifconfig Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address, default gateway address) for the printer. ❖ View settings msh> ifconfig ❖ IPv4 Configuration msh> ifconfig "interface_name" "parameter" "address" • If you did not enter an interface name, it is automatically set to the Ethernet interface. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name ether wlan Interface configured Ethernet Interface IEEE 802.11b Interface The following explains how to configure an IPv4 address 192.168.15.16 on Ethernet interface. msh> ifconfig ether 192.168.15.16 68