Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 152

STORING, USING AND DELETING JOB PROGRAMS The steps of up to 10 copy jobs can be stored as job programs. Job programs can be called up with ease, and are retained even when the power is turned off. By storing frequently used copy settings in a job program, you can eliminate the bother of selecting the settings each time you use them for a copy job. ●If any settings related to the steps of a job program are changed in the administrator settings after the job program is stored, the steps related to the changed settings will not be included when the job program is called up. ●To exit the job programs mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on the touch panel. Storing a job program 1 Press the [#/P] key. LOGOUT 2 Touch the [STORE/DELETE] key. 5 Touch the [OK] key. NCEL OK AUTO ORIGINAL The selected settings will be stored in the number key selected in step 3. AUTO M NUMBER. RECALL STORE/DELETE 3 Touch the number key ([1] to [10]) in which you wish to store the job program. PROGRAMS ESS PROGRAM NUMBER. Number keys in which job programs are already stored are highlighted. RECALL STORE/ ■ If a number key is selected in step 3 that has already been programmed. A setting confirmation screen will appear. To replace the existing program with the new program, touch the [STORE] key and continue from step 4. If you do not wish to replace the existing program, touch the [CANCEL] key to return to the screen of step 3 and select a different number key. NOTE If overwriting of programmed copy settings has been prohibited in the administrator settings, it will not be possible to store or delete a job program. (See page 17 of the administrator settings guide.) 4 Select the copy settings that you wish to store in the job program. TO STORE, MAKE SELECTIONS AND PRESS [OK], TO DELETE, PRESS [CANCEL]. SPECIAL MODES The number of copies cannot be stored. 2-SIDED COPY OUTPUT 1. 2. 81/2x11 81/2x11 3. 81/2x14 4. 11x17 5-44