Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 154

INTERRUPTING A COPY RUN The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job. 1 Touch the [INTERRUPT] key. INTERRUPT If interrupt copying is possible during a copy AUTO run, the [INTERRUPT] ORIGINA key will appear. (If the 23 AUTO key does not appear, 81/2x11 EXPOSUR interrupt copying is not AUTO A4 possible.) CANCEL 0 When the [INTERRUPT] key is touched in step 1, ORIGINAL A4 AUTO EXPOSURE AUTO 81/2x11 PAPER SELECT the [INTERRUPT] key will be replaced by the [CANCEL] key as shown in the illustration. 100% COPY RATIO To cancel an interrupt copy job while the interrupt original is being scanned or while you are selecting copy settings, touch the [CANCEL] key. 2 Place the original for the interrupt copy job in the document feeder or on the document glass (page 4-3). 3 Select the exposure mode, paper size, number of copies, and any other copy settings as needed, and then press the [START] key. NOTES ● If you touch the [INTERRUPT] key when auditing mode is enabled, the display will prompt you to enter your account number. Enter your account number with the numeric keys. The copies you make will be added to the count of the entered account number. ● If a copy is being printed when the [INTERRUPT] key is pressed, interrupt mode will begin after the copy is finished. ● If the copy run to be interrupted is using paper from the bypass tray, the paper size and type of the bypass tray cannot be changed for use by the interrupt job. ● If the document glass is used for an interrupt copy job, two-sided copying, sort copying, and staple sort copying cannot be selected. If any of these functions are necessary, use the document feeder. 4 The previous copy job automatically resumes after the interrupt job finishes. 5-46