Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 80

INSERTER ■ Alarm display If the [START] key indicator on the inserter operation panel is blinking and the [PUNCH] key or [STAPLE] key indicator is also blinking or solidly lit, operation will not start when the [START] key is pressed. Resolve the problem as indicated below, depending how the indicators are lit or blinking. [PUNCH] indicator [STAPLE] indicator [START] indicator Cause Solution Any one of the indicators is solidly lit. Solidly - - - - lit Blinking - - - - Any one of the - indicators is blinking. - - - - - Blinking Blinks red Blinks red Blinks red Blinks red Blinks red A paper size that cannot be fed has been loaded. Use paper that is a suitable size for punching, stapling, or saddle stitching (page 3-3). The paper type of the inserter is set to heavy paper. Heavy paper cannot be used. The finisher or saddle stitch finisher tray is full. Remove the paper from the tray. The hole punch scrap Discard the hole punch container in the punch scrap (page 3-10). module on the finisher or saddle stitch finisher is full. The finisher or saddle stitch finisher tray is full. Remove the paper from the tray. The finisher or saddle stitch finisher is out of staples. Replace the staple cartridge (page 3-7). The saddle stitch tray on Remove the paper from the saddle stitch finisher is the saddle stitch tray. full. The saddle stitch finisher is Replace the saddle stitch out of saddle stitch staples. staple cartridge (page 3- 8). ■ Using the inserter For paper sizes that can be stapled or punched, see the finisher and saddle stitch finisher specifications on page 3-2. Some paper types cannot be stapled or punched (see "NOTES" on page 3-3). Do not use these paper types. 1 Load paper in the inserter. NOTE Paper guide Load the paper face up. When performing pamphlet stapling, place the paper so that the opened pages are face up as shown. Adjust the paper guide to the size of the paper. 2 Press the desired mode key. Press key 2 on page 3-15 for stapling or pamphlet stapling. Press key 1 on page 3-15 for punching. The selected mode lights up. Pamphlet stapling can only be used when the saddle stitch finisher (AR-F16) is installed. When using pamphlet stapling, stapling and punching cannot be used in combination. 3 Press the [START] key. Make sure that the [START] key light is illuminated green and then press the [START] key. 3-16