Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 74

FINISHER AND SADDLE STITCH FINISHER ■ Removing a staple jam in the saddle stitch finisher 1 Perform steps 1 to 3 of the procedure for "Replacing the cartridge in the saddle stitch finisher" on page 3-8. 2 Remove the empty staple case. 5 Return the staple case to its original position. 3 While pushing down on lever (A), pull up knob (B) . (A) (B) 4 Remove any jammed staples, and then return knob (B) to its original position. (B) Be sure to remove any strips of staples. 6 Return the saddle stitch holder and the saddle stitch unit to their respective original positions. 7 Make sure that the finisher is firmly attached to the machine and that 11" x 17", 8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or B4) size paper is loaded. If one of the above paper sizes is not set, test stapling cannot be performed. 8 Close the lower cover of the finisher. Test stapling is automatically performed on a blank sheet. This operation is carried out to avoid blank stapling. NOTE If test stapling fails to take place, repeat steps 1 to 7. Jammed staples NOTE Do not touch the stapling area. The stapler could injure you. ■ Disposal of hole punch scrap (when the punch module is installed) 1 Open the cover of the hole punch module. 2 Holding the black handle, slide out the case containing the paper bits, and dispose of them properly. 3-10 3 Return the waste case to its original position. 4 Close the cover of the hole punch module.