Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 39

LOADING PAPER ■ Loading paper in the AR-LC7 If the paper runs out during printing, a message will appear in the display. Follow the procedure below to load paper. 1 Pull the tray out until it stops. Pull the finger grip up and pull the tray out until it stops. CAUTION When loading paper, take care not to insert your hands into holes on paper table. Do not insert your hands here. 2 NOTE To add or change paper, press the operation button. When the button is pressed, the indicator will blink until the paper table stops descending. Do not pull the tray out until the indicator turns off. Attempting to pull the tray out when the indicator is blinking or solidly lit may damage the tray. 2 Place the paper on the paper table. The paper stack must not be higher than the indicator line. When the paper tray is Indicator line pulled out, the paper table will have descended to a position where approximately 500 sheets of 8-1/2" x 11" size (A4) 20lbs. (80g/m2) paper can be placed. After the paper is placed, the paper table will descend to a position where an additional approximately 500 sheets can be placed. When the paper table has descended all the way, approximately 3000 sheets can be held. If a different type of paper is loaded that was used previously, the paper settings for tray 5 must be changed on the machine. Be sure to change to the appropriate settings as explained in "Setting the paper type and paper size" on page 2-14. NOTES Do not insert objects in the tray or attempt to place spare paper in the tray. This may damage the tray. ● Use SHARP-recommended paper (page 2-22). Special paper cannot be used. 3 Push the tray firmly all the way into the machine. After the tray is pushed in, the indicator will blink until the paper table finishes ascending and then light solidly. 2-9