Sharp MX-M700 MX-M550 MX-M620 MX-M700 Operation Manual - Page 71
Staple cartridge replacement and staple jam removal
View all Sharp MX-M700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
FINISHER AND SADDLE STITCH FINISHER Staple cartridge replacement and staple jam removal When a finisher is installed, a message will appear when the staple cartridge runs out of staples or a staple jam occurs. Follow the procedure below to replace the staple cartridge or remove jammed staples. ■ Replacing the cartridge in the finisher 1 Open the front cover of the finisher. 5 Pull the seal that holds the staples straight out. 2 Lower the blue lever in the stapler and slide out the staple cartridge. 3 6 Insert the cartridge all the way in until it clicks into place. Insert the cartridge all the way in until it clicks into place. 3 Pull the empty staple case straight up and out of the cartridge. 7 Close the front cover of the finisher. 4 Insert a new staple case into the cartridge. Push the staple case all the way in until it clicks into place. Do not remove the seal holding the staples until the staple case is set in the cartridge. NOTE Make a test print or copy in the staple sort mode to verify that stapling is performed properly. 3-7