Toshiba Portege M100 Maintenance Manual - Page 201

3 Tests and Diagnostics 3.28 Bluetooth Test Program Table 3-7 Common Error code Error code Meaning 0x30 0x31 0x32 0x33 0x34 0x35 0x36 0x37 0x38 0x39 0x3a 0x3b 0x3c 0x3d 0x3e 0x3f 0x40 0x41 0x42 0x43 0x44 0x45 0x46 0x47 0x48 0x49 0x4a 0x4b 0x4c 0x4d 0x4e 0x4f BT Control Status should be "Disable", but it is "Enable". BT Control Status should be "Enable", but it is "Disable". Power Status should be "OFF", but it is "ON". Power Status should be "ON", but it is "OFF". USB I/F Status should be "Attach", but it is "Detach". USB I/F Status should be "Detach", but it is "Attach". Wake-up Status should be non-"Assert", but it is "Assort". Wake-up Status should be "Assert", but it is non-"Assort". Switch Status should be "OFF", but it is "ON". Switch Status should be "ON", but it is "OFF". Module dose not exist. Module exists. (not error) Command Line is wrong. Side band access driver is not resident. Bluetooth driver for DOS is not resident. Get Status function of Side band access driver is not normal. No reply to inquiry Device Descriptor can not be acquired. USB I/F is not normal. Sideband reset timeout occurs. Descriptor type is wrong. Descriptor is acquired in spite of Detach condition. Configuration file open is not normal. Contents of Configuration file are wrong. BD_ADDR is wrong (00) BD_ADDR is wrong (FF) BD_ADDR is wrong (bit0=1) BD_ADDR is wrong (bit1=1) BD_ADDR is wrong (address defined as an error) Suspended during Hard ware switch confirmation. RSSI value is less than the standard value. Holts (reserved) ** Number 0x30 to 0x40 are common error codes of the test program. 3-92 PORTEGE M100 Maintenance Manual (960-452)