Home » ZyXEL Manuals » Networking » ZyXEL MAX318M » Manual Viewer

ZyXEL MAX318M User Guide - Page 278

注意, FCC Radiation Exposure Statement, Notices

Get ZyXEL MAX318M PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 278 highlights

Appendix E Legal Information frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio/television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1 Reorient or relocate the receiving antenna. 2 Increase the separation between the equipment and the receiver. 3 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4 Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. • To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. d dʮ̡e e f i dᏐͭу৾͜d f d f e f f dሗѼቇԴ͜f Notices Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device is designed for the WLAN 2.4 GHz and/or 5 GHz networks throughout the EC region and Switzerland, with restrictions in France. Ce produit est conçu pour les bandes de fréquences 2,4 GHz et/ou 5 GHz conformément à la législation Européenne. En France métropolitaine, suivant les décisions n°03-908 et 03-909 de l'ARCEP, la puissance d'émission ne devra pas dépasser 10 mW (10 dB) dans le cadre d'une installation WiFi en extérieur pour les fréquences comprises entre 2454 MHz et 2483,5 MHz. 278 WiMAX Device Configuration User's Guide

Section	Page
WiMAX CPE Series	1
About This User's Guide	3
Document Conventions	4
Safety Warnings	6
Contents Overview	7
Table of Contents	9
User’s Guide	15
Introduction to the Series	17
1.1 About Your WiMAX Device	17
1.1.1 WiMAX Internet Access	18
1.1.2 Models with Phone Ports	18
1.1.3 Models with WiFi	19
1.2 Good Habits for Managing the WiMAX Device	19
Introduction to the Web Configurator	20
2.1 Overview	20
2.1.1 Accessing the Web Configurator	20
2.1.2 Saving and Canceling Changes	21
2.1.3 Working with Tables	21
2.2 The Main Screen	22
Setup Wizard	25
3.1 Overview	25
3.1.1 Welcome to the Setup Wizard	25
3.1.2 LAN Settings	26
3.1.3 WiMAX Frequency Settings	27
3.1.4 WiMAX Authentication Settings	28
3.1.5 VoIP Settings	30
3.1.6 WLAN Settings	32
3.1.7 Setup Complete	34
Tutorials	35
4.1 Overview	35
4.2 WiMAX Connection Settings	35
4.3 Setting Up a Small Network for the LAN	36
4.4 Making a Telephone Call Over the Internet	38
4.4.1 Configure Your SIP Account	38
4.5 Blocking Web Access from the WiMAX Device	40
4.6 Restricting Wireless Access to the WiMAX Device	40
4.7 Allowing Internet Users to use Internal Servers	42
4.8 Access the WiMAX Device with a Domain Name	44
4.8.1 Registering a DDNS Account on www.dyndns.org	45
4.8.2 Configuring DDNS on Your WiMAX Device	46
4.8.3 Testing the DDNS Setting	46
4.9 Configuring Static Route for Routing to Another Network	46
4.10 Remotely Managing Your WiMAX Device	48
4.11 Changing Certificate to Communicate with Other Networks	49
4.12 Using Virtual Networks	50
4.12.1 Scenario 1	51
4.12.2 Scenario 2	52
4.12.3 Scenario 3	54
4.12.4 Scenario 4	56
4.12.5 Scenario 5	58
Technical Reference	61
System Status	63
5.1 Overview	63
5.2 System Status	63
WiMAX	67
6.1 Overview	67
6.1.1 What You Need to Know	67
6.2 Connection Settings	70
6.3 Frequency Settings	72
6.4 Authentication Settings	74
6.5 Channel Plan Settings	77
6.6 CAPL Settings	79
6.6.1 CAPL Settings: Add	80
6.7 RAPL Settings	81
6.8 Home NSP Settings	82
6.9 Connect	83
6.10 Wide Scan	85
6.11 Link Status	87
6.12 Link Statistics	88
6.13 Connection Info	89
6.14 Service Flow	89
Network Setting	91
7.1 Overview	91
7.1.1 What You Need to Know	91
7.2 WAN	94
7.3 PPPoE	96
7.4 GRE	97
7.5 EtherIP	98
7.6 IP	98
7.7 DHCP	99
7.8 WLAN	100
7.9 WPS	102
7.10 MAC Address Filter	103
7.11 Static Route	104
7.12 Static Route Add	104
7.13 RIP	105
7.14 Port Forwarding	107
7.14.1 Port Forwarding Wizard	108
7.15 Port Trigger	108
7.15.1 Port Trigger Wizard	110
7.15.2 Trigger Port Forwarding Example	111
7.16 DMZ	111
7.17 ALG	112
7.18 QoS	113
7.19 UPnP	113
7.19.1 Installing UPnP in Windows XP	114
7.19.2 Web Configurator Easy Access	118
7.20 VLAN	119
7.21 DDNS	121
7.22 IGMP Proxy	123
7.23 Content Filter	123
Security	125
8.1 Overview	125
8.1.1 What You Need to Know	125
8.2 IP Filter	125
8.3 MAC Filter	126
8.4 DDOS	127
8.5 PPTP VPN Server	129
8.6 PPTP VPN Client	130
8.7 PPTP VPN Client: Add	131
8.8 L2TP VPN Server	133
8.9 L2TP VPN Client	135
8.10 L2TP VPN Client: Add	135
8.11 IPSec VPN	137
8.11.1 IPSec VPN: Add	139
8.12 Technical Reference	144
8.12.1 IPSec Architecture	144
8.12.2 Encapsulation	145
8.12.3 IKE Phases	146
8.12.4 Negotiation Mode	147
8.12.5 IPSec and NAT	147
8.12.6 VPN, NAT, and NAT Traversal	148
8.12.7 ID Type and Content	148
8.12.8 Pre-Shared Key	150
8.12.9 Diffie-Hellman (DH) Key Groups	150
The VoIP General Screens	151
9.1 VoIP Overview	151
9.1.1 What You Need to Know	151
9.1.2 Before you Begin	152
9.2 Media	153
9.3 QoS	154
9.4 SIP Settings	155
9.5 Speed Dial	155
9.6 Technical Reference	156
9.6.1 DSCP and Per-Hop Behavior	156
The VoIP Account Screens	157
10.1 Overview	157
10.1.1 What You Need to Know	157
10.2 Status	160
10.3 Server	161
10.4 SIP	163
10.5 Feature	165
10.6 Dialing	166
10.7 FAX	167
10.8 Technical Reference	167
10.8.1 SIP Call Progression with Session Timer	167
10.8.2 SIP Client Server	170
The VoIP Line Screens	171
11.1 Overview	171
11.1.1 What You Need to Know	171
11.2 Phone	172
11.3 Voice	172
11.4 Region	173
Maintenance	175
12.1 Overview	175
12.1.1 What You Need to Know	175
12.2 Password	180
12.3 HTTP	181
12.4 Telnet	181
12.5 SSH	182
12.6 SNMP	183
12.7 CWMP	183
12.8 OMA-DM	185
12.9 Date/Time	187
12.10 Time Zone	187
12.11 Upgrade File	188
12.11.1 The Firmware Upload Process	189
12.12 Upgrade Link	189
12.13 CWMP Upgrade	189
12.14 Backup/Restore	190
12.15 Restore	190
12.15.1 The Restore Configuration Process	191
12.16 Factory Defaults	191
12.17 Log Setting	192
12.18 Log Display	192
12.19 Network Test	193
12.20 Traceroute	194
12.21 About	194
12.22 Reboot	195
Troubleshooting	197
13.1 Power, Hardware Connections, and LEDs	197
13.2 WiMAX Device Access and Login	198
13.3 Internet Access	199
13.4 Wireless Internet Access (for Models with WiFi)	201
13.5 Phone Calls and VoIP (for Models with Phone Ports)	201
13.6 Reset the WiMAX Device to Its Factory Defaults	202
13.6.1 Pop-up Windows, JavaScript and Java Permissions	202
Product Specifications	203
WiMAX Security	207
Importing Certificates	211
Common Services	237
Open Software Announcements	241
Legal Information	277

Match case Limit results 1 per page

Appendix E Legal Information

WiMAX Device Configuration User’s Guide

278

frequency energy, and if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation.

If this device does cause harmful interference to radio/television reception, which can be

determined by turning the device off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

•

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

•

To comply with FCC RF exposure compliance requirements, a separation distance of at least 20

cm must be maintained between the antenna of this device and all persons.

注意

依據

低功率電波輻射性電機管理辦法

第十二條

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用

者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

第十四條

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現

有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。

前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍

受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

本機限在不干擾合法電臺與不受被干擾保障條件下於室內使用。

減少電磁波影響，請妥適使用。

Notices

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This device is designed for the WLAN 2.4 GHz and/or 5 GHz networks throughout the EC region and

Switzerland, with restrictions in France.

Ce produit est conçu pour les bandes de fréquences 2,4 GHz et/ou 5 GHz conformément à la

législation Européenne. En France métropolitaine, suivant les décisions n°03-908 et 03-909 de

l’ARCEP, la puissance d’émission ne devra pas dépasser 10 mW (10 dB) dans le cadre d’une

installation WiFi en extérieur pour les fréquences comprises entre 2454 MHz et 2483,5 MHz.