ZyXEL MAX318M User Guide - Page 71

Chapter 6 WiMAX Click WiMAX > Profile > Connection Settings to open this screen as shown next. Figure 26 Connection Settings Screen This screen contains the following fields: Table 12 Connection Settings LABEL DESCRIPTION Connection Option Settings Auto Reconnect Select the interval in seconds that the WiMAX Device waits after getting disconnected from the base station before attempting to reconnect. Auto Connect Mode Select the auto connect mode. • By channel power - Auto connects to the base station if the signal strength of the channel is sufficient for the WiMAX Device. • By CINR - Auto connects to the base station if the signal-to-noise ratio is sufficient for the WiMAX Device. Enable Handover Select this to maintain connectivity while the WiMAX Device switches its connection from one base station to another base station. Enable MS Initiated Idle Mode Select this to have the WiMAX Device enter the idle mode after it has no traffic passing through for a pre-defined period. Make sure your base station also supports this before selecting this. Idle Mode Interval Set the idle duration in minutes. This is how long the WiMAX Device waits during periods of no activity before going into idle mode. CINR & RSSI Refresh Interval Set the refresh interval in milliseconds for calculating the signal-to-noise measurement (CINR) and signal strength measurement (RSSI) of the WiMAX Device. LDRP (Low Data Rate Protection) Enter the Low Data Rate Protection (LDRP) time in milliseconds. If the uplink/ downlink data rate is smaller than the LDRP time, the WiMAX Device sends a disconnect request to the base station. LDRP TX Rate Enter the outgoing data rates for LDRP in bytes per second. LDRP RX Rate Enter the incoming data rates for LDRP in bytes per second. Connection Type Settings WiMAX Device Configuration User's Guide 71