Brother International HL-3400CN Service Manual - Page 143

FIL-3400CN SERV10E MANUAL Code No. 16-4 16-5 16-6 17 18 LCD Message ALIGN BELT CG 16 ALIGN BELT CG [*4] ALIGN LFU 16 ALIGN LFU [*4] . ALIGN TRANSFER ROLLER 16 ALIGN BELT CG [*4] MEDIA JAM 17 MEDIA JAM [*7] [*4] CLOSE PANEL 18 CLOSE PANEL [*B] [*4] Description of Message • The engine is stopped. • The Ready LED is lit. • The OPC belt cartridge is not installed. Reconfirm the installation status of the OPC belt cartridge. • This message will be automatically cleared by opening & closing either the paper exit cover or front cover. • The engine is ready to print. • Turn the power off and connect the harness between the engine and fusing unit. • Turn the power on. If the warming-up process starts, it means that proper connection is now made. • The engine is ready to print. • The Ready LED is lit. • The transfer roller is not installed. Reconfirm the installation status of the transfer roller. • This message will be automatically cleared by opening & closing either the paper exit cover or front cover. • The engine is stopped. • The Ready LED is lit. [*71: The kind of jam (location of jam) is indicated as follows; FEED: Paper feeder INNER: Inside of the printer OUTER: Paper exit unit DRUM: Transfer drum DPL: Inside the duplex unit • This message can be cleared by pressing the Font button after opening & closing the front cover, back cover and paper exit cover. • The engine is ready to print. • The Ready LED is lit. [*81: The open cover is indicated as follows; FRONT: Front cover TOP: Paper exit cover REAR: Rear access cover DPL: Rear access cover LFU: Fusing unit cover • This message can be cleared by opening & closing the indicated cover. 5-21