Brother International HL-3400CN Service Manual - Page 234
diagonally
UPC - 012502526223
View all Brother International HL-3400CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
CHAPTER 7 DISASSEMBL Y & RE-ASSEMBLY NOTE: • For easier removal, push the drum upwards and diagonally forwards. • When re-assembling the transfer drum 3, slide the drum shaft between the metalplates and ensure the drum is fully located into the correct retaining position. A PRECAUTION Do not touch the transfer drum surface with your bare hands or scratch it. Protect the drum surface during handling. 4.2.11 Erase lamp 31Erase holder (1) Disconnect the harness (1 pc.) connected to the erase lamp 3. (2) Remove the erase lamp 3 from the holder. •----""--- Holder Erase holder Harness Erase lamp 3 Erase holder Fig. 7-41 NOTE: When re-assembling the erase lamp 3, check the correct direction referring to the figure below. Failure to do so may cause transfer drum damage. (Left Side) i I r i (Right Side) Fig. 7-42 7-30