Brother International HL-3400CN Service Manual - Page 44
Print/next
UPC - 012502526223
View all Brother International HL-3400CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
HL-3400CN SERVICE MANUAL (6) Press the Sel button to set the printer off-line. The On Line LED goes off. (7) Hold down the Shift button and press the Test button so that the printer enters the test mode. (8) Press the A or V button to scroll through the display until the desired test mode appears, then press the Set button to print the desired test page. NOTE: Refer to the table below for each test mode item. Display Message DEMO PAGE TEST PRINT PRINT CONFIG PRINT FONTS I PRINT FONTS C PRINT FONTS P Exit Test Mode Description Prints out the demonstration. Performs the printer test and prints out the test pattern. Prints out a list of panel button settings you have configured as user settings for the printer. Prints out a list of internal or resident fonts. Prints out a list of optional fonts stored in the font cartridge/card. Prints out a list of permanent download fonts. Exits from the test mode. The printer does not perform any test. (9) Push the power button in order to shut off the power supply to the printer. NOTE: Use the following procedures to identify the problem if the test print is incorrect. (10) Press and hold down the Mode, Set (a) and V buttons and press the power button to go into the Engine Controller Mode. The Ready LED lights within 210 seconds maximum when the screen (a) on the right appears on the control panel display. 00 READY U: LT /UPP (11) Press the Sel button after warming-up (b) is completed, then screen (b) on the right appears on the control panel display. SERVICE MODE >TEST PRINT/NEXT (12) Press the Continue button, then screen (c) on the right appears. (c) 31 GRID PRT I> GRID/STRIPE 3-15