Canon LBP 2460 Service Manual - Page 178
High-voltage Power Supply PCB,
View all Canon LBP 2460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
CHAPTER 3 10) Disconnect the connector, remove the 2 screws, and pull out the board. Disconnect the other connector and remove the switch/sensor PCB. G. High-voltage Power Supply PCB 1) Remove the right rear and rear covers. 2) Disconnect the 2 connectors, remove the 4 screws, then take out the high-voltage power supply unit. Connectors Screws Switch/sensor PCB Connectors Screws High-voltage power supply unit Figure 3-7-12 Figure 3-7-13 3) Disconnect the 2 claws and remove the high-voltage power supply PCB. 3 - 36
10) Disconnect the connector, remove the 2
screws, and pull out the board.
Disconnect the other connector and
remove the switch/sensor PCB.
Connectors
Screws
Switch/sensor PCB
Figure 3-7-12
G.
High-voltage Power Supply PCB
1)
Remove the right rear and rear covers.
2)
Disconnect the 2 connectors, remove the
4 screws, then take out the high-voltage
power supply unit.
Connectors
Screws
High-voltage power supply unit
Figure 3-7-13
3)
Disconnect the 2 claws and remove the
high-voltage power supply PCB.
CHAPTER 3
3 - 36