Canon LBP 2460 Service Manual - Page 262
M-19 No Paper Pick-Up from Envelope feeder, Action, M-20 No Paper Pick-Up from Paper deck, M-21
![]() |
View all Canon LBP 2460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 262 highlights
CHAPTER 4 M-19 No Paper Pick-Up from Envelope feeder 1. Video controller PCB is defective. Action: Use the printer driver tester to make a test print from the envelope feeder. If the envelope is picked up correctly from the envelope feeder, replace the video controller PCB. 2. Gears are damaged. Action: Remove the envelope feeder and check the gears. Replace any damaged gears. 3. The envelope feeder pick-up motor is defective. Action: Use the printer driver tester to rotate the envelope feeder pick-up motor. If it does not rotate, replace it. 4. The envelope feeder driver PCB is defective. Action: Replace the envelope feeder driver PCB. 5. The DC controller PCB is defective. Action: Replace the DC controller PCB. M-20 No Paper Pick-Up from Paper deck 1. Damaged part in the paper pick-up drive unit. Action: Remove the pick-up unit and replace any damaged parts. 2. Faulty pick-up solenoid Action: Remove pick-up solenoid connector J115. Measure the resistance between connectors J115-1 and J115-2 on the cable side. If it is not about 190 , replace the pick-up solenoid. 3. Defective pick-up motor Action: Load one sheet of paper into the paper deck. Then after shorting jumpers JP201-2 (TEST-1) and JP201-1 (GND) on the paper deck driver PCB, turn the printer power switch ON. If the pick-up motor does not rotate at that time, replace the motor. 4. Defective paper deck driver PCB Action: Replace the paper deck driver PCB. 5. Defective option controller PCB. Action: Replace the option controller PCB. 6. Defective video controller PCB. Action: Replace the video controller PCB. M-21 Registration Roller not rotating (printer) 4 - 48
![](/manual_guide/products/canon-lbp-2460-service-manual-2642b58/262.png)