Canon LBP 2460 Service Manual - Page 257
M-9 Electrical Unit Fan FM3 Failure, Action, M-10 Fixing Unit Fan FM4 Failure, M-11 Lifting Plate
View all Canon LBP 2460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
CHAPTER 4 M-9 Electrical Unit Fan (FM3) Failure 1. The FM3 drive signal line connector is loose. Action: Reconnect connector J210 on the DC controller PCB and connectors J12 and J13. 2. The electrical unit fan is defective. Action: Disconnect connector J210 on the DC controller PCB. Turn the power switch ON and measure the voltage between connector J210-1 (FAN3D) and J210-3 (GND) on the DC controller PCB. If the voltage changes from 0 to more than 18V, replace the electrical unit fan. 3. The DC controller PCB is defective. Action: Replace the DC controller PCB. M-10 Fixing Unit Fan (FM4) Failure 1. The FM4 drive signal line connector is loose. Action: Reconnect connector J225 on the DC controller PCB and connectors J25 and J26. 2. The fixing unit fan is defective. Action: Disconnect connector J225 on the DC controller PCB. Turn the power switch ON and measure the voltage between connector J225-1 (FAN4D) and J225-3 (GND) on the DC controller PCB. If the voltage changes from 0 to more than 18V, replace the fixing unit fan. 3. The DC controller PCB is defective. Action: Replace the DC controller PCB. M-11 Lifting Plate Failure 1. Lifting plate drive unit parts are damaged. Action: Replace any damage parts. 2. The lifting plate position sensor is defective. Action: Check the sensor state using the printer driver tester. If it is defective, replace the multi-purpose tray PCB. 3. The lifting plate solenoid is defective. Action: Disconnect lifting plate solenoid connector J1302. Measure the resistance between connectors J1302-1 and J1302-2 on the cable side. If it is not about 100Ω, replace the lifting plate solenoid. 4. The DC controller PCB is defective. Action: Replace the DC controller PCB. 4 - 43