Canon LBP 2460 Service Manual - Page 226

CHAPTER 4 c. Itemize the Data Set Select SET UP with the DISPLAY/SET UP switch. Various settings and commands can be made according to the DATA SET (see table 4-2-3). For example, when commanding a test print pick-up, delivery tray allocation or pattern setting operation, follow the steps below by operating the the tester. (when you want to have paper picked-up from the multi-purpose tray, duplex-print a horizontal line test print pattern and deliver it through the face up tray.) 1) When the printer has entered standby mode, set the DISPLAY/SET UP switch on the tester to "SET UP". 2) Set the MODE SELECT to "8". 3) Set DATA SET switch bit 8 to 0, bit 7 to 1, bit 6 to 0, bit 5 to 0, bit 4 to 1, bit 3 to 1, bit2 to 0 and bit 1 to 1 (see Table 4-2-6). 4) Press the ENTER switch. 5) By turning the TEST PRINT switch ON once, a test print can be made. PRINTER DRIVER DATA bit 16 bit 15 bit 14 bit 13 bit 12 bit 11 bit 10 bit 9 bit 8 bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 DC24V x  ‹ e TEST DATA SET ENTER PRINT MODE SELECT bit 8 bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 1 1 1 1 1 1 1 1 ON DISPLAY 5 67 4 8 3 9 0 0 0 0 0 0 0 0 2 OFF SET UP 1 10 11 RY9-0104 CANON INC. MADE IN JAPAN Horizontal lines (image pattern) setting Duplex print setting Face-up tray delivery allocation Multi-purpose tray pick-up allocation Figure 4-2-6 Notes: 1. After setting a test print in this mode, the data will remain the same even if the test print is set in another mode. 2. By keeping the TEST PRINT switch "ON", continuous test prints will be made. 3. When setting the image pattern to "All black", do not make duplex prints. 4 - 12