Canon LBP 2460 Service Manual - Page 247

CHAPTER 4 Message Meaning Action must be opened and closed to resume. printing. 14.2 PAPER JAM Paper jam has occured in the feed cover. Check the Paper Deck. Remove OPEN RIGHT the jammed paper from the COVER paper path. The upper cover must be opened and closed to resume. printing. 14.3 PAPER JAM Paper jam has occured in the feed cover. Check the Paper Deck. Remove OPEN RIGHT the jammed paper from the COVER paper path. The upper cover must be opened and closed to resume. printing. OPTIONS Option controller error with paper deck. Reconnect the paper deck to the CONTROLLER printer. DUPLEX COVER The delivery cover is open. Close the cover. OPEN OPT CONTROLLER There is a problem with the Option Replace the option controller. ERROR Controller OPTCONTROLLER There is a problem with the Option Replace the option controller. COMMUNICATIONS Controller ERROR MEMORY Memory overflow. The printer received The job will resume after 10 OVERFLOW more data than it can fit into its available seconds if AUTOCONT is ON. memory. This can happen if too many soft Otherwise press the CONTINUE fonts, macros, or graphics which are too key to resume printing. Check the complex are received. page that ejects since the could not be processed as requested. Also simplify the job or add additional memory. ERROR DISK CALL Hard Drive Failure - Read Error - Replace the hard disk. FOR SERVICE MEMORY ALLOC GRS has been unable to allocate the The job will resume after 10 ERROR memory it needs. seconds if AUTOCONT is ON. Otherwise press the CONTINUE key to resume printing. Check the page that ejects since the could not be processed as requested. 1 NETWORK Bad NIC in slot 1. Replace the NIC. OPTION ERROR 2 NETWORK Bad NIC in slot 2. Replace the NIC. OPTION ERROR 43 PS OPTION Option PS ROM (DIMM) diagnostic error. An option ROM has failed its ERROR startup checksum and needs to be replaced. EXP I/O ERROR: LocalTalk error, where ## is the number. These are problems with the ## 00 Shared Memory test error 8051 (LocalTalk) card. These 01 CRC receive error errors will be displayed and the 02 Receive over-run error printer will halt. 4 - 33