Home » Canon Manuals » Laser Printers » Canon LBP 2460 » Manual Viewer

Canon LBP 2460 Service Manual - Page 30

Paper deck, Opening the packaging, Installation,

Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

CHAPTER 1 6. Paper deck a. Opening the packaging 1) Open the paper deck packaging and remove the box. 2) Take out the accessories. Confirm that the power cord, manuals and interface cable are included. 3) Remove the top pads (left/right) and remove the paper deck from the box. 4) Take off the plastic bag surrounding the paper deck and peel off the tape holding the various parts. Confirm that none of the covers were scratched or deformed during shipment. 5) Open the feed cover and remove the 2 spacers. 6) Open the deck and peel the tape off. 7) Peel off the tape holding the latch of the paper guide. b. Installation 1) Carry the paper deck to the installation location and lock the casters. 2) Rotate the 4 adjusters to install it on the floor. 3) Open the feed cover. 4) Align the paper deck and the printer in the same direction, and have 4 people lift the printer. Lower the printer onto the paper deck while aligning the 3 locating pins on the paper deck. 5) Close the feed cover. 6) Connect the paper deck and the printer with an interface cable. 1 - 18 14pin Figure 1-5-5 15pin 14pin

Section	Page
PREFACE	5
CONTENTS	7
CHAPTER 1	11
I. FEATURES	13
II. SPECIFICATIONS	15
III. SAFETY INFORMATION	19
IV. PARTS OF THE PRINTER	20
V. INSTALLATION	26
VI. MAINTENANCE AND SERVICING BY THE CUSTOMER	35
VII. OPERATION	37
CHAPTER 2	45
I. BASIC OPERATION	47
II. ENGINE CONTROL SYSTEM	50
III. LASER/SCANNER SYSTEM	72
IV. IMAGE FORMATION SYSTEM	78
V. PICK-UP/FEED SYSTEM	88
VI. OVERALL CONTROL SYSTEM	106
VII. OPTION CONTROL SYSTEM	110
VIII. ENVELOPE FEEDER	113
IX. DUPLEXING UNIT	117
X. PAPER DECK	127
CHAPTER 3	141
I. EXTERNALS	143
II. DRIVE SYSTEM	152
III. PAPER TRANSPORT SYSTEM	154
IV. EXPOSURE SYSTEM	163
V. ELECTROSTATIC IMAGING/DEVELOPING/CLEANING SYSTEM	164
VI. FIXING SYSTEM	166
VII. ELECTRONIC COMPONENTS	174
VIII. ENVELOPE FEEDER	181
IX. DUPLEXING UNIT	187
X. OPTION CONTROLLER	194
XI. PAPERDECK	195
CHAPTER 4	213
I. MAINTENANCE AND SERVICING	215
II. TOOLS	219
III. MEASUREMENT AND ADJUSTMENT	228
IV. INITIAL CHECK	232
V. IMAGE DEFECTS	233
VI. MALFUNCTION TROUBLESHOOTING	242
VII. PAPER FEEDING TROUBLESHOOTING	265
VIII. LOCATION OF ELECTRICAL PARTS/FUNCTION	272
IX.VARIABLE RESISTORS, LEDS, TEST PINS, JUMPERS, AND SWITCHES ON PC BOARDS	287
X. LIST OF LUBRICANTS, CLEANERS	296
APPENDIX	297
I. GENERAL TIMING CHART-1/2	299
GENERAL TIMING CHART-2/2	300
II. GENERAL CIRCUIT DIAGRAM-1/3	301
GENERAL CIRCUIT DIAGRAM-2/3	302
GENERAL CIRCUIT DIAGRAM-3/3	303