Canon LBP 2460 Service Manual - Page 209
Rear wire,
![]() |
View all Canon LBP 2460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
CHAPTER 3 b. Rear wire 1) Insert the pulley alignment pin in the left side(looking from the front) of the shaft. 2) Wind the wire one and a half times starting from the second groove from the front of pulley 2 and insert it on to the shaft. 3) Wind the wire one and a half times starting from the second groove from the back of pulley 1 and insert it on to the shaft. 4) Secure the pulleys with the E-ring. Shaft Pulley alignment pin Wires Pulley 2 Pulley 1 E-ring Figure 3-11-43 3 - 67
![](/manual_guide/products/canon-lbp-2460-service-manual-2642b58/209.png)
b.
Rear wire
1)
Insert the pulley alignment pin in the left side(looking from the front) of the shaft.
2)
Wind the wire one and a half times starting from the second groove from the front of pulley 2
and insert it on to the shaft.
3)
Wind the wire one and a half times starting from the second groove from the back of pulley 1
and insert it on to the shaft.
4)
Secure the pulleys with the E-ring.
Shaft
Pulley alignment pin
Wires
Pulley 2
Pulley 1
E-ring
Figure 3-11-43
CHAPTER 3
3 - 67